annuler
Affichage des résultats de 
Rechercher plutôt 
Vouliez-vous dire : 

FAQs

Trier par :
In this case, a residual current discharge (power supply reset) can help.
Afficher l'article complet
If your memory card is no longer recognized, it needs to be repaired or replaced.
Afficher l'article complet
Check the primary side power supply and, if present, the on / off switch of the power supply.
Afficher l'article complet
Please check the power supply first.
Afficher l'article complet
The following steps may help if your device does not turn off.
Afficher l'article complet
There may be a cable break, one of the most common signs of wear on electrical equipment.
Afficher l'article complet
Due to the routine clockwise rotation of the vacuum cleaner, it happens that the device themselve cover the virtual wall.
Afficher l'article complet
The alarm center receives firmware updates via OTA (Over the Air).
Afficher l'article complet
During cooling, the compressor continues to run.
Afficher l'article complet
This FAQ gives you the temperature range of the air conditioning system.
Afficher l'article complet
This can be rectified by updating the device firmware to version V0.3.7.
Afficher l'article complet
In this FAQ you will find useful information about your robot vacuum cleaner.
Afficher l'article complet
You can change the amount of water dispensed in the Life+ app.
Afficher l'article complet
Follow the individual points in this FAQ.
Afficher l'article complet
Additional cleaning agents can damage the robot vacuum cleaner.
Afficher l'article complet
Follow the instructions in this FAQ.
Afficher l'article complet
Follow the steps mentioned in this FAQ.
Afficher l'article complet
You can find the error diagnosis on the MEDION Service page.
Afficher l'article complet
The sensors are probably dirty or corroded. Here we explain how to proceed.
Afficher l'article complet
The contacts of the dirty water tank are dirty, clean them carefully.
Afficher l'article complet
Principaux contributeurs