cancel
Showing results for 
Search instead for 
Did you mean: 

FAQs

Sort by:
To upgrade your RAM, know the memory generation, voltage, number of pins and clock rate. Switch off the computer and disconnect it from the power supply before installing the RAM.
View full article
Each appliance has a type plate with MSN / MD number. Depending on the appliance type, this can be found on the underside, rear, inside or on the packaging.
View full article
Here you will find detailed instructions for setting up a RAID array on the specified mainboards, including access to the BIOS to activate the necessary configurations.
View full article
The serial number is written on a sticker on the back of the Smart TV, sometimes S / N is not noted in front of the number.
View full article
The baskets have the dimensions of 15.5 cm (6.1 inch) in width, 12.5 cm (4.9 inch) in height, and 23 cm (9.0 inch) in depth.
View full article
The ERAZER ControlCenter software can be used to activate or deactivate the USB ports in sleep mode or when switched off, even without a connected power supply unit.
View full article
A subsequent update will fix the problem.
View full article
Switch to PERSONAL mode to customize your TV picture settings.
View full article
The NUM Lock function is probably active. Switch it off by pressing the SHIFT + FN + NUM Lock, FN + Ins or FN + NUM buttons simultaneously.
View full article
Here you will find detailed technical information about the mainboard.
View full article
Here you will find detailed technical information about the mainboard.
View full article
Install the software patch by downloading the file, unzipping it and executing it with administrator rights to activate the CoPilot button.
View full article
You can use the antenna connection with either the included wire antenna or another antenna that has a coaxial plug.
View full article
Sparks occur if the mains cable is plugged in before connecting to the audio system. To avoid this, first insert the plug into the device and then into the socket.
View full article
Due to their mechanical components, hard drives can make noises. If unusual noises occur, it is recommended to check the status of the hard drive using system commands and, if necessary, to use the manufacturer's diagnostic software.
View full article
Optimise your Desktop PC with a BIOS update for your mainboard, but please note that this is done at your own risk and MEDION accepts no liability.
View full article
In standby mode, press the ‘Start time’ button on the remote control until the time flashes on the display. Then press the yellow button on the remote control to confirm the setting.
View full article
Check whether the transport protection film is still on the display and remove it if necessary.
View full article
First find the desired station and save it according to the instructions. Then switch to FM mode for at least three seconds, after which the station should be permanently stored.
View full article
The overheating protection is activated if there is not enough cooling air in the appliance. This is a safety function and the appliance can be used again after about an hour.
View full article
Top Contributors