abbrechen
Suchergebnisse werden angezeigt für 
Stattdessen suchen nach 
Meintest du 

FAQs

Sortieren nach:
The sensors are set up via the Smart Home app.
Vollständigen Artikel anzeigen
You are not using the latest BIOS.
Vollständigen Artikel anzeigen
First disconnect the dishwasher from the mains.
Vollständigen Artikel anzeigen
There are two different variants.
Vollständigen Artikel anzeigen
Make sure that the crockery has enough space and that the spray arms can work unhindered to ensure thorough cleaning. To achieve optimum results, the machine must be set and maintained correctly.
Vollständigen Artikel anzeigen
To ensure that the crockery dries properly, follow the points in this FAQ.
Vollständigen Artikel anzeigen
If there is a whistling noise, then the tap of the water inlet is probably not turned on properly, or food residues have slipped through the sieve and are hanging in the drain hose.
Vollständigen Artikel anzeigen
Unpleasant odours can be caused by a lack of cleaning or long standing times with leftover food. Regular cleaning of the interior and the use of the hottest programme with special cleaning agents can help.
Vollständigen Artikel anzeigen
Without a front panel, the door of an undercounter dishwasher will not close properly and may spring out of its anchoring. It should therefore be closed carefully in this case.
Vollständigen Artikel anzeigen
Check the possible causes in this FAQ.
Vollständigen Artikel anzeigen
Water can leak out of the sides of household appliances if the door seal is damaged or dirty. Heating the warped rubber with a hair dryer and cleaning the seals can solve the problem.
Vollständigen Artikel anzeigen
Rust stains are caused by salt or rusty basket areas. A short programme without dishes after refilling with salt and sealing rusty basket areas will help to prevent this.
Vollständigen Artikel anzeigen
Error code E52 indicates that the water cannot drain properly.
Vollständigen Artikel anzeigen
The aluminium cutlery or other aluminium parts must not come into contact with the dishes.
Vollständigen Artikel anzeigen
This can happen if there are too few dishes in the appliance during the wash cycle.
Vollständigen Artikel anzeigen
This can happen if the wrong detergent is used or rinse aid is spilled.
Vollständigen Artikel anzeigen
The error codes E3 and E7 indicate a defect in the heater or sensor.
Vollständigen Artikel anzeigen
If the device does not pump out water, this may be due to a blocked strainer.
Vollständigen Artikel anzeigen
By opening the door immediately after the end of the programme, a stream of warm air should come out of the machine.
Vollständigen Artikel anzeigen
The appliance is not drawing water, the water pressure is too low or the aquastop has been triggered.
Vollständigen Artikel anzeigen
Top-Beitragsleistende