FAQs

The appliance is not drawing water, the water pressure is too low or the aquastop has been triggered.

The error code E8 says that the corner valve is defective.

This can happen if the wrong cleaner is used.

This can happen due to a combination of too soft water and too much detergent.

First, please check whether all inlet valves are open.

You can calculate the water pressure approximately with the help of a 10-litre water bucket and a stopwatch

Check the socket if the dishwasher does not switch on. If the display works but the programme does not start, check the door seal and clean the sieves and nozzles.

You can tell whether the Aquastop has been triggered and the valve has interrupted the water supply by looking at the window or the indicator field of the mechanical Aquastop system.

You can find this information in the Windows Task-Manager.

In this FAQ we explain the most common faults of your robot vacuum cleaner.

Order a suitable remote control via the MEDION Service Shop using your MSN number or model name.

The UV-C lamp only becomes active when you press the safety switch and at the same time apply pressure to the rollers.

Install the MEDION Speaker App, activate the Wi-Fi mode on the MD 44007 and follow the app's instructions to connect via your smartphone's Wi-Fi settings.

To clean the dust container and the permanent filter, empty the container and clean the filter. To do this, open the appliance lid, remove the dust container and filter and empty both, rinse with water if necessary, clean the filter with a brush and replace everything after it has dried.

Tips for changing a WLAN system to a new one.

Tips and tricks for the sustainable descaling of your coffee maker.

MEDION devices use an alphanumeric code. Contact the manufacturer of the universal remote control, as the codes are defined there and vary depending on the remote control.

Perform a reception diagnosis as follows.

You can find all the information you need in this FAQ.

Temporarily install another language, change your system to it and now exit S-mode.