annuler
Affichage des résultats de 
Rechercher plutôt 
Vouliez-vous dire : 

FAQs

Trier par :
To ensure that the crockery dries properly, follow the points in this FAQ.
Afficher l'article complet
If there is a whistling noise, then the tap of the water inlet is probably not turned on properly, or food residues have slipped through the sieve and are hanging in the drain hose.
Afficher l'article complet
Unpleasant odours can be caused by a lack of cleaning or long standing times with leftover food. Regular cleaning of the interior and the use of the hottest programme with special cleaning agents can help.
Afficher l'article complet
Without a front panel, the door of an undercounter dishwasher will not close properly and may spring out of its anchoring. It should therefore be closed carefully in this case.
Afficher l'article complet
Check the possible causes in this FAQ.
Afficher l'article complet
Water can leak out of the sides of household appliances if the door seal is damaged or dirty. Heating the warped rubber with a hair dryer and cleaning the seals can solve the problem.
Afficher l'article complet
Rust stains are caused by salt or rusty basket areas. A short programme without dishes after refilling with salt and sealing rusty basket areas will help to prevent this.
Afficher l'article complet
Error code E52 indicates that the water cannot drain properly.
Afficher l'article complet
The aluminium cutlery or other aluminium parts must not come into contact with the dishes.
Afficher l'article complet
This can happen if there are too few dishes in the appliance during the wash cycle.
Afficher l'article complet
This can happen if the wrong detergent is used or rinse aid is spilled.
Afficher l'article complet
The error codes E3 and E7 indicate a defect in the heater or sensor.
Afficher l'article complet
If the device does not pump out water, this may be due to a blocked strainer.
Afficher l'article complet
By opening the door immediately after the end of the programme, a stream of warm air should come out of the machine.
Afficher l'article complet
The appliance is not drawing water, the water pressure is too low or the aquastop has been triggered.
Afficher l'article complet
The error code E8 says that the corner valve is defective.
Afficher l'article complet
This can happen if the wrong cleaner is used.
Afficher l'article complet
This can happen due to a combination of too soft water and too much detergent.
Afficher l'article complet
First, please check whether all inlet valves are open.
Afficher l'article complet
You can calculate the water pressure approximately with the help of a 10-litre water bucket and a stopwatch
Afficher l'article complet
Principaux contributeurs