cancel
Showing results for 
Search instead for 
Did you mean: 

FAQs

Sort by:
There are two different variants.
View full article
Make sure that the crockery has enough space and that the spray arms can work unhindered to ensure thorough cleaning. To achieve optimum results, the machine must be set and maintained correctly.
View full article
To ensure that the crockery dries properly, follow the points in this FAQ.
View full article
If there is a whistling noise, then the tap of the water inlet is probably not turned on properly, or food residues have slipped through the sieve and are hanging in the drain hose.
View full article
Unpleasant odours can be caused by a lack of cleaning or long standing times with leftover food. Regular cleaning of the interior and the use of the hottest programme with special cleaning agents can help.
View full article
Without a front panel, the door of an undercounter dishwasher will not close properly and may spring out of its anchoring. It should therefore be closed carefully in this case.
View full article
Check the possible causes in this FAQ.
View full article
Water can leak out of the sides of household appliances if the door seal is damaged or dirty. Heating the warped rubber with a hair dryer and cleaning the seals can solve the problem.
View full article
Rust stains are caused by salt or rusty basket areas. A short programme without dishes after refilling with salt and sealing rusty basket areas will help to prevent this.
View full article
Error code E52 indicates that the water cannot drain properly.
View full article
This can happen if there are too few dishes in the appliance during the wash cycle.
View full article
This can happen if the wrong detergent is used or rinse aid is spilled.
View full article
The error codes E3 and E7 indicate a defect in the heater or sensor.
View full article
If the device does not pump out water, this may be due to a blocked strainer.
View full article
By opening the door immediately after the end of the programme, a stream of warm air should come out of the machine.
View full article
The appliance is not drawing water, the water pressure is too low or the aquastop has been triggered.
View full article
The error code E8 says that the corner valve is defective.
View full article
This can happen if the wrong cleaner is used.
View full article
You can calculate the water pressure approximately with the help of a 10-litre water bucket and a stopwatch
View full article
You can tell whether the Aquastop has been triggered and the valve has interrupted the water supply by looking at the window or the indicator field of the mechanical Aquastop system.
View full article
Top Contributors