cancel
Showing results for 
Search instead for 
Did you mean: 

FAQs

Sort by:
You can use the antenna connection with either the included wire antenna or another antenna that has a coaxial plug.
View full article
Switch off the device, clean the lens on the bumper and test the mobility of the bumper. Then lift the robot and check the underside of the front bumper for foreign objects, which should be removed if necessary.
View full article
The grill does not switch off due to a fault, the indicator light goes out when the temperature is reached. If there are problems with heating up, check the socket, extension cable and temperature control connection.
View full article
If warm air gets inside the fridge, the moisture will freeze when it cools down. To avoid this, the door should not be left open for long, it must close properly and only cooled food should be placed inside.
View full article
Flashes or sparks in the microwave are caused by dirt, metal objects or a scratched coating. Switch off the microwave immediately to prevent damage.
View full article
Sparks occur if the mains cable is plugged in before connecting to the audio system. To avoid this, first insert the plug into the device and then into the socket.
View full article
A slow or crashing system may be due to outdated software or full hard drives. Update regularly and use tools such as the MEDION Service App to detect errors.
View full article
Use the MSInfo32 program, which is started by entering ‘msinfo32’ in the Run dialogue (Windows key + r). There you will find the mainboard designation under ‘System overview’ behind ‘BaseBoard product’.
View full article
MEDION devices use an alphanumeric code. Contact the manufacturer of the universal remote control, as the codes are defined there and vary depending on the remote control.
View full article
Check in the settings under HDMI EDID whether HDMI 1.4 is selected and change it from 2.0 to 1.4 if necessary.
View full article
Switch off the refrigerator, unplug the mains plug, remove the lamp cover and replace the bulb with a suitable one.
View full article
Fold a handkerchief into a square, place it over the ink tank sealing lever and secure the filling opening with adhesive tape to prevent the ink from leaking.
View full article
Switch off the keyboard, remove the 2.4G receiver, press ESC + Q and plug the receiver back in. For the mouse, hold down the scroll wheel and the right mouse button while switching it on and then plug in the receiver. Bring both devices close to the receiver until the flashing stops.
View full article
Place a switched-on flashlight inside and switch off the room light. If light shines through, the seal is leaking. For glass doors, stick a piece of paper in the door and pull it out. If there is no tension, the seal may be defective.
View full article
Due to their mechanical components, hard drives can make noises. If unusual noises occur, it is recommended to check the status of the hard drive using system commands and, if necessary, to use the manufacturer's diagnostic software.
View full article
Install the Life+ app, connect your smartphone to a 2.4 GHz Wi-Fi network and follow the instructions in the app to pair the robot vacuum cleaner. After a successful connection, the app will display a confirmation message.
View full article
Optimise your Desktop PC with a BIOS update for your mainboard, but please note that this is done at your own risk and MEDION accepts no liability.
View full article
In standby mode, press the ‘Start time’ button on the remote control until the time flashes on the display. Then press the yellow button on the remote control to confirm the setting.
View full article
Press the Power and WPS buttons simultaneously. Press and hold the buttons for 3 seconds.
View full article
Hold down the ‘Shift key’ when clicking on ‘Restart’ in the Start menu or use the command ‘shutdown -g -t 0’ in the Run dialog.
View full article
Top Contributors