annuler
Affichage des résultats de 
Rechercher plutôt 
Vouliez-vous dire : 

FAQs

Trier par :
Tipps for cleaning washing machines.
Afficher l'article complet
The door remains closed until all water has been removed.
Afficher l'article complet
Electrical devices require a reliable power supply.
Afficher l'article complet
Make sure that you only use incandescent lamps with a power of 220-240V, max. 10W. The thread should be E14.
Afficher l'article complet
There is a printing error in the operating instructions.
Afficher l'article complet
First disconnect the dishwasher from the mains.
Afficher l'article complet
There are two different variants.
Afficher l'article complet
The error code E8 says that the corner valve is defective.
Afficher l'article complet
If there is a whistling noise, then the tap of the water inlet is probably not turned on properly, or food residues have slipped through the sieve and are hanging in the drain hose.
Afficher l'article complet
Error code E52 indicates that the water cannot drain properly.
Afficher l'article complet
The aluminium cutlery or other aluminium parts must not come into contact with the dishes.
Afficher l'article complet
This can happen if there are too few dishes in the appliance during the wash cycle.
Afficher l'article complet
This can happen if the wrong detergent is used or rinse aid is spilled.
Afficher l'article complet
The error codes E3 and E7 indicate a defect in the heater or sensor.
Afficher l'article complet
If the device does not pump out water, this may be due to a blocked strainer.
Afficher l'article complet
You can tell whether the Aquastop has been triggered and the valve has interrupted the water supply by looking at the window or the indicator field of the mechanical Aquastop system.
Afficher l'article complet
By opening the door immediately after the end of the programme, a stream of warm air should come out of the machine.
Afficher l'article complet
This can happen if the wrong cleaner is used.
Afficher l'article complet
This can happen due to a combination of too soft water and too much detergent.
Afficher l'article complet
First, please check whether all inlet valves are open.
Afficher l'article complet
Principaux contributeurs