annuleren
Resultaten voor 
Zoek in plaats daarvan naar 
Bedoelde u: 

FAQs

Sorteren op:
Question Why does the water from the washing machine not drain away?   Answer If the device does not pump out water, the pump filter may be clogged. The water then remains inside the device and no longer flows out. The first thing to do is to remove the pump filter. Then clean it under running water. If a clogged pump filter can be ruled out, the machine should be pulled forward a bit and checked to make sure the drain hose is not kinked or crushed or below the water level of the drum. If the washing machine still does not work, it is necessary to have it checked by a service technician.   The information in this article refers to: MEDION washing machines ZAYBYC (IRIS-Symptom-Code_A12)   Article in other languages: Deutsch Review Date: 2023-01-04
Volledig artikel weergeven
The transport lock must be removed before initial start-up.
Volledig artikel weergeven
Tipps for cleaning washing machines.
Volledig artikel weergeven
The door remains closed until all water has been removed.
Volledig artikel weergeven
Electrical devices require a reliable power supply.
Volledig artikel weergeven
There is a printing error in the operating instructions.
Volledig artikel weergeven
First disconnect the dishwasher from the mains.
Volledig artikel weergeven
There are two different variants.
Volledig artikel weergeven
The error code E8 says that the corner valve is defective.
Volledig artikel weergeven
If there is a whistling noise, then the tap of the water inlet is probably not turned on properly, or food residues have slipped through the sieve and are hanging in the drain hose.
Volledig artikel weergeven
Error code E52 indicates that the water cannot drain properly.
Volledig artikel weergeven
The aluminium cutlery or other aluminium parts must not come into contact with the dishes.
Volledig artikel weergeven
This can happen if there are too few dishes in the appliance during the wash cycle.
Volledig artikel weergeven
This can happen if the wrong detergent is used or rinse aid is spilled.
Volledig artikel weergeven
The error codes E3 and E7 indicate a defect in the heater or sensor.
Volledig artikel weergeven
If the device does not pump out water, this may be due to a blocked strainer.
Volledig artikel weergeven
You can tell whether the Aquastop has been triggered and the valve has interrupted the water supply by looking at the window or the indicator field of the mechanical Aquastop system.
Volledig artikel weergeven
By opening the door immediately after the end of the programme, a stream of warm air should come out of the machine.
Volledig artikel weergeven
This can happen if the wrong cleaner is used.
Volledig artikel weergeven
This can happen due to a combination of too soft water and too much detergent.
Volledig artikel weergeven
Topbijdragers