on 13.04.2024 22:52
on 13.04.2024 22:52
Hi,
I want to remove the Phison ps5012-e12s-32 M.2 SSD that came pre installed with my Medion Erazer X10. However, when unscrewing the SSD, it doesn't come up in a 30% angle like M.2 SSD's usually do but simply stays in the same horizontal angle as it is when screwed down. Any advice on how can I remove it? Thanks in advance. Kind regards
on 14.04.2024 10:10
on 14.04.2024 10:10
Hello @NexxOne_ and welcome
The release spring from the port may be stuck. Manually lift the card by about 30 degrees and then pull it out. remove them like this.
bye Fishtown
on 14.04.2024 10:10
on 14.04.2024 10:10
Hello @NexxOne_ and welcome
The release spring from the port may be stuck. Manually lift the card by about 30 degrees and then pull it out. remove them like this.
bye Fishtown
on 23.04.2024 08:30
on 23.04.2024 08:30
Hi Fishtown,
Thanks for your response. In the end the old M.2 was stuck to the little sticky thermal block at the bottom. However, your comment did give me assurance that I could just lift it up without braking it. I had to hold the block while lifting the SSD and eventually it came off. Thanks!