About shaman101

shaman101 · ‎12.11.2024

No there is no beeps. There is no ssd/hdd inside. Or maybe there is an msata ssd somewhere installed, because it is mentioned here in the post by Razz.

shaman101 · ‎11.11.2024

Hi again! I tried one more time with the media creation tool, but it does not matter if i make the stick with the tool, it wont boot. I think maybe there is a little msata ssd, or one of the ram sticks are bad. Unfortunately i cant reach the ram slots, 'cause they are under the keyboard, so i have to completely dissassembly it first.

shaman101 · ‎08.11.2024

Thank you i will try, but i've already tried sticking in an usb stick with uefi OS. Any button i press while booting makes no change.

shaman101 · ‎08.11.2024

Yes, those drives are missing. But first it booted to bios with no problem. I dont know what did i change there, but since then it wont boot to bios. I've already tried putting hdd/ssd in, no change.

shaman101 · ‎08.11.2024

Hi, and thank you for the response. Unfortunately i cant get past the medion logo boot screen. First when i brought it home, it got into bios instantly, but since then it wont boot to bios. Maybe the msata drive is corrupted ? i thought it had a 2.5 ssd drive, rather than the msata ssd, i have to check for the msata drive, but i dont know where to find it. i've bought it without any kind of drive. It has the mxm videocard and the rams installed for sure. No any other peripherals.

shaman101 · ‎31.10.2024

Greetings and hi all! I have an erazer x7830 notebook. When first i brought home and powered on, it took me in the bios, so i changed some values in bios, and after that it will not go through the "medion logo". I've already tried resetting the cmos battery, i've disconnected the battery from the motherboard.I give her a new thermal paste, already taken out the cpu and put it back in. I tried to clean the ports if there is a short circuit. I've reseated the mxm videocard also. It has no ssd/hdd, but the rams are in their slot, but not on the rear side where the cpu and heatsinks are, rather at the front, and i dont know how to disconnect the keyboard to reach the ramslots. I've tried to unscrew the keyboard holding screws on the back, but unfortunately there are more screws holding the keyboard. I think i have to dissassembly the whole system. Any ideas what gone wrong ? The laptop is in new condition by the way. Anyone has a service document for this modell, i would really appreciate it!

Date Registered	‎31.10.2024 18:29
Date Last Visited	‎12.11.2024 14:07
Total Messages Posted	6

About shaman101

Re: Erazer x7830

Re: Erazer x7830

Re: Erazer x7830

Re: Erazer x7830

Re: Erazer x7830

Erazer x7830

Legal information

MEDION products and shops

About MEDION