Hi daddle thanks for coming back i have tried to answer all the points. 1. When I start the computer up i get 5 short beeps each time at the moment this has only started since i formatted. 2.short 3. The screen stays black if i hold down as per my other update earlier when i press keys my asus screen power button is amber with no picture but if i don't press anything or press the keys as i mentioned that don't change anything the screen loads and i have picture with the windows sign, underneath it states 'preparing' like its going to install windows and that's when i get the install windows error as mentioned, the picture showing this is above your post to me now. I have also tried leaving this to see if it would install but it doesn't. 4. Yes i have tried this so completely turn off with both the power button and using the switch on the back of the power unit where power cable is but so far no luck with bios loading at any point. I tried this with delete and f keys, is there another key i should try? 5. Yes as per above the only picture i have had since i completed the format is the screen where windows looks like it is about to install but other than that the screen light is amber and no picture so no light on the screen. 6. Yes i have the usb i created on my other machine as a bootable usb when i i try this i still get the beeps and nothing loads so still stuck with the black screen and the windows attempting to install does not load, is there anything i should be holding or pressing with this inserted i tried already with nothing being pressed and delete etc but nothing. 7. Tried as you said with the f8 f10 before any power goes to the pc and i have the amber screen with computer on so no picture although it never gets to the windows load error with the usb in the computer. 8/9.no its completely dark with the power button to the screen lit as orange, only time the screen power button as turned blue so far is when i get the windows preparing screen and then the error message, if you click ok or trying closing the error it just recycles and goes again. 10. So i pulled the hard-drive cable out and tried to see if it loaded the usb and again it didnt, i plugged it into my other pc to make sure it has all the content and it does show it as a bootable image on the usb stick, when i used the windows tool these are the settings i used - create installation media / language english / edition windows 10 / architecture - both / usb flash drive / esd G which is the usb stick. Thanks
... View more