Informationen zu Colas

Colas · ‎01.10.2021

Hi @Gehringer the LEDs are all on, fans are working and I can hear the HDD that I installed spin. To me it look like either the 3070 GPU is not working, if I unplug/plug the video cable the monitor notices it but it does not get any signal and goes back to sleep, or the system is stuck in using the internal GPU which does not exists or has no connector. I have seen a similar post here in the Medion community but there was no solution. Strange, I wanted to try the interruption of the boot process and when I now switched it on it worked. I don't know if the times that I did remove the power yesterday fixed it. I will keep observing it. Regards, Ángel

Colas · ‎01.10.2021

Hi, I have bought a Medion Erazer X10 - MD35071 a few weeks ago. It was working fine but since yesterday it powers on automatically when I switch on the plug where it is connected and it only shows a black screen. I have tried to access the BIOS with all the possible key combinations but it does not show anything. It does not even show the Medion logo. I don't know if it is booting or just stuck in the BIOS. The only way to power it off again is to cut the power completely. I have also tried different monitors, keyboards.... but nothing has worked. Regards, Ángel

Registrierdatum	‎01.10.2021 08:00
Datum des letzten Besuchs	‎01.10.2021 16:05
Summe gesendete Nachrichten	2
Summe erhaltener Kudos	3

Informationen zu Colas

Re: Medion Erazer X10 - MD35071 - Black screen and...

Medion Erazer X10 - MD35071 - Black screen and aut...

Rechtliche Informationen

MEDION Shops

Über MEDION