cancel
Showing results for 
Search instead for 
Did you mean: 

Lifetab P10505 Software Update

SOLVED
5 REPLIES 5
TerryofFrome
Trainee
Message 1 of 6
7,897 Views
Message 1 of 6
7,897 Views

Lifetab P10505 Software Update

Hello,

I have a Lifetab P10505 tablet which is going well. However, an update named "LIFETAB P1050x Software v2.7" has recently appeared which doesn't update!  I have taken out the memory card in case this is the problem, but it runs for some time and then stops! Any ideas on this? I have given the tablet a 100% charge each time. I have tried quite a few times, but that is as far as I have got.

Terry

1 ACCEPTED SOLUTION

Accepted Solutions
TerryofFrome
Trainee
Message 5 of 6
8,920 Views
Message 5 of 6
8,920 Views

Thanks Bart,

You were right! I did the factory reset, then when I tried the update to version 2.7 all went well. If anyone else has that problem, that is the answer. It is a great pity that Medion doesn't include that in the instructions for the update.

Terry

View solution in original post

5 REPLIES 5
Bodgekin
Mentor
Message 2 of 6
7,883 Views
Message 2 of 6
7,883 Views

Hi @TerryofFrome

 

I presume this is an OTA update you are trying to install? Could it be that the problem is network related? So the update already fails while downloading? I would expect that if it fails while actually updating, you would end up with half an Android installation. Do you get any errors which could point us in the right direction? And did you perform a factory reset before starting the update?

 

Kind regards,
Bart
TerryofFrome
Trainee
Message 3 of 6
7,880 Views
Message 3 of 6
7,880 Views

Hi Bodgekin,

I didn't do a factory reset prior to trying the update. Should I have done that? Thanks for your reply.

TerryC

Bodgekin
Mentor
Message 4 of 6
7,860 Views
Message 4 of 6
7,860 Views

Hi @TerryofFrome

 

I dont think it is always required, but I always do to make sure that there are no apps installed that could potentially cause conflicts etc. 

Especially since the updates fails for you, I'd just do a factory reset and try it again.

 

Kind regards,
Bart
TerryofFrome
Trainee
Message 5 of 6
8,921 Views
Message 5 of 6
8,921 Views

Thanks Bart,

You were right! I did the factory reset, then when I tried the update to version 2.7 all went well. If anyone else has that problem, that is the answer. It is a great pity that Medion doesn't include that in the instructions for the update.

Terry

Bodgekin
Mentor
Message 6 of 6
7,847 Views
Message 6 of 6
7,847 Views

Hi Terry, 

 

Awesome, glad it worked :).

Kind regards,
Bart
5 REPLIES 5