annuler
Affichage des résultats de 
Rechercher plutôt 
Vouliez-vous dire : 

FAQs

Trier par :
Rust stains are caused by salt or rusty basket areas. A short programme without dishes after refilling with salt and sealing rusty basket areas will help to prevent this.
Afficher l'article complet
Error code E52 indicates that the water cannot drain properly.
Afficher l'article complet
The aluminium cutlery or other aluminium parts must not come into contact with the dishes.
Afficher l'article complet
This can happen if there are too few dishes in the appliance during the wash cycle.
Afficher l'article complet
This can happen if the wrong detergent is used or rinse aid is spilled.
Afficher l'article complet
The error codes E3 and E7 indicate a defect in the heater or sensor.
Afficher l'article complet
If the device does not pump out water, this may be due to a blocked strainer.
Afficher l'article complet
By opening the door immediately after the end of the programme, a stream of warm air should come out of the machine.
Afficher l'article complet
The appliance is not drawing water, the water pressure is too low or the aquastop has been triggered.
Afficher l'article complet
The error code E8 says that the corner valve is defective.
Afficher l'article complet
This can happen if the wrong cleaner is used.
Afficher l'article complet
This can happen due to a combination of too soft water and too much detergent.
Afficher l'article complet
First, please check whether all inlet valves are open.
Afficher l'article complet
You can calculate the water pressure approximately with the help of a 10-litre water bucket and a stopwatch
Afficher l'article complet
Check the socket if the dishwasher does not switch on. If the display works but the programme does not start, check the door seal and clean the sieves and nozzles.
Afficher l'article complet
You can tell whether the Aquastop has been triggered and the valve has interrupted the water supply by looking at the window or the indicator field of the mechanical Aquastop system.
Afficher l'article complet
You can find this information in the Windows Task-Manager.
Afficher l'article complet
In this FAQ we explain the most common faults of your robot vacuum cleaner.
Afficher l'article complet
Order a suitable remote control via the MEDION Service Shop using your MSN number or model name.
Afficher l'article complet
The UV-C lamp only becomes active when you press the safety switch and at the same time apply pressure to the rollers.
Afficher l'article complet
Principaux contributeurs