on 05.01.2020 14:38
I recently purchased this device, but have not been able to set it up correctly.
Tried setup via WPS and manual wifi setup, with DHCP and with manual ip setup, turned off wifi 5Ghz to avoid conflict/connection to this separate network...
Steps taken: power on the device, open the app, click "set up audio system", put the device in SETUP mode (blinks regularly and slowly), press next in the app, select the UNDOK_00:... network broadcasted by the device, my phone connects to that network, enter "Medion" as a name for the device, select "Wi-Fi" as connection method, select the correct network and enter the password, press next; the device stops broadcasting the UNDOK_00:... network, and the phone reconnects to my home network (= same as selected in the app obviously). Then the app scans for the device, but times out. It shows a warning that the audio system cannot be found on the network.
Strangely - I think this must be related to the problem - on the webpage of my router, I can see the Medion device in the network (most of the time) as connected, but cannot ping it.
any help would be appreciated,
on 06.01.2020 13:19
Hi @Mark and welcome to the forum!
I think you are not following the proper procedure for establishing the Wireless connection. You are close to it though.
Please try the following procedures, recommended by the user guide of your product:
Please let us know if that solved the problem.
on 06.01.2020 22:03
Thank you for your reply.
I retried (this time WPS), configuration seems to work, but again the connection via the app fails; I recorded a short video of the blinking led pattern: white led stays on for like 10 seconds, then briefly blinks a few times, finally the continues light is restored again (process repeats).
on 13.01.2020 16:48
No suggestions any more? I guess it's a hardware issue and that there's nothing left than to return the product...
on 14.01.2020 16:41
Yes I did; the led on the device starts to blink slowly, this is setup mode, and the device broadcasts a wifi signal used to enter the wifi credentials for the regular home network. However, after entering all of the data (as an alternative to WPS setup), the device is not to be found after that setup procedure, even after a longer time.
The led then turns on for like 10 seconds (indicating it made the connection), then starts to blink briefly. See also my video in the third post of this thread.
on 16.01.2020 11:30
Hi @Mark ,
there are a couple of other things you could try before determining that it is a HW fault.
Have you tried to connect with the device using another phone?
Have you verified that the wifi on the phone was on and that both devices were connected to the same network?
on 16.01.2020 13:46
Hello @Gehringer ,
yes I tried using different Android devices (v6.0 and v9.0), same result. Also tried the app where the Medion app was based on.
The wifi was on, and I verified that the devices (phone and medion audio device) where on the same network, same wifi frequency band (as seen on the router home page, so no mistakes there I guess).